Required Tools Time: 15 mins Preparation TURN THE GAME OFF – Do not attempt to install this kit with the game powered on. Remove the glass from the game. Remove all the balls from the game and lift the playfield into the service position. See the game manual if you are unsure how to do …
Required Tools No tools required. Time: 5 mins Remove the wire from the plugs on the power splitter. Plug one end of the wire into the CN6 connector on the backbox. Plug the second end on the far right plug on the power splitter. Stick the power splitter to the backbox where it is the …
Required Tools No tools required. Time: 5 mins Power Module Install TURN OFF YOUR GAME – Game must Always be turned off prior to connecting or disconnecting the power module. Open the speaker panel by inserting the back-box key and turning it. Lower the speaker panel down into the position shown above. Locate your Spike …
There is no excerpt because this is a protected post.
Required Tools Time Required: 10 minutes NOTE: We now include two extension cables in our advanced under cabinet kit. This allows you to place a single bar behind the head if you would like to to allow patterns to be displayed behind the game. You must connect all the bars together and into the U …
Below are the instructions on how to operate the Spike 2 advanced control box running software revision 1.5. Note this version is only compatible with control boxes R1.4 and above. Buttons Your control box contains 3 main buttons. BACK DOWN UP ENTER We will reference these buttons in the instructions below. Note: When operating the …
Spike 2 Advanced Control Box Instructions – Software Version 1.5 Read More »
Required Tools No tools required. Time: 5 mins Speaker Insert Install Take your speaker frames out of the package. Place the left frame on the left side and the right frame on the right side. Flip the speaker frames upside down so the wires are coming out of the top of the frames. The right …
Required Tools No tools required. Time: 5 mins Control Box Install TURN OFF YOUR GAME – Game should always be turned off when connecting or disconnecting the control box. Open the speaker panel by inserting the back-box key and turning it. Lower the speaker panel down into the position shown above. Locate your advanced control …
Spike 2 Advanced Control Box R1.4 / R1.5 Install Instructions Read More »
Requirements Windows Machine (Email us for Mac Support) Firmware Software Micro-USB Cable Connect Your Control Box Disconnect your control box from your Spike 2 game and disconnect the light extension cables by pushing on the tabs and pulling the connectors apart. NOTE: Do Not Attempt to Install a Software Update With the Game Plugged In …
How to Update Software on Advanced Control Box R1.4 Read More »
Below are the instructions on how to operate the Spike 2 advanced control box running software revision 1.4 Buttons Your control box contains 3 main buttons. SELECT UP DOWN We will reference these buttons in the instructions below. Note: When operating the buttons please keep your hands away from any HIGH VOLTAGE areas of your …
Spike 2 Advanced Control Box Instructions Software R1.4 Read More »
