Required Tools
- No tools required.
Time: 5 mins
Power Module Install
TURN OFF YOUR GAME – Game must Always be turned off prior to connecting or disconnecting the power module.
Open the speaker panel by inserting the back-box key and turning it. Lower the speaker panel down into the position shown above.
Locate your Spike 2 CN6 Power Module R2
Doesn’t look like the above? You might have a different power supply. Click here for R1 instructions.
Locate the CN6 connector on the right side of your backbox. It is directly above the caps but below the CN1 connector.
Locate the CN6 connector on the Power Box (NOTE: Your connector may look different, but it will be labeled CN6)
Connect the CN6 connector.
NOTE: The RED wire will always be at the bottom. The color of the return wire may vary and will be either in the middle or top position of the connector.
Connect the power module to your control box where it says “5V IN”. You may need to wiggle the connector slightly when attaching so it clears the circuit board base.
You are now done with the power module installation.