Required Tools
- No tools required.
Time: 5 mins
Control Box Install
TURN OFF YOUR GAME – Game should always be turned off when connecting or disconnecting the control box.
Open the speaker panel by inserting the back-box key and turning it. Lower the speaker panel down into the position shown above.
Locate your advanced control box.
Note: Revision 1.5 has a large white header on the left side instead of the individual wires.
Locate the 5v Power In connector on your control box.
Connect the power connector from your CN6 power module and plug into the control box. Note you may need to angle the connector a bit to install to clear the circuit board, however do not force the connector in.
Note the two tabs are on the top when connected and the RED or bright wire should be towards the top of the box.
Connect your speaker cables, under-cabinet kit cables (if equipped) and back-box kit cables(if equipped) into the control box. Look at the labels on the control box to connect the cables to the correct connector.
| Label | Connect To |
| R | Right Speaker Frame |
| L | Left Speaker Frame |
| U | Under-Cabinet Light Kit |
| B | Backbox Light Kit (Not Released Yet) |
Note: When disconnecting the cables, be sure to press in the tab and grab the connector sides (not the wires) when pulling to disconnect.
Turn on your game and your control box should now boot up and you are up and running.
You are now all installed! See our guide on our support page on how to use the control box.